Factors affecting the efficiency of sand blasting machine and safe operation procedures-Honest Horse china garnet sand

Factors affecting the efficiency of sand blasting machine and safe operation procedures

The use efficiency of sand blasting machine is affected by the following three factors, so before use, it is necessary to understand the influencing factors in advance, so as to better improve the use efficiency of equipment and reduce the occurrence of equipment failures.
1. For the air pressure supplied by the air compressor, it is recommended to buy an air compressor with good quality and sufficient air supply.
2. The quality of abrasive of sandblasting equipment is good or bad. It is recommended to buy abrasive of sandblasting equipment.
The above is the factor that affects the use efficiency of sand blasting machine. According to its introduction, it can better promote the use of equipment, reduce equipment failure, and promote the extension of the service life of equipment while improving the use efficiency of equipment.

Below, we will understand the operation procedures in detail to ensure the safety of the equipment.
1. The air storage tank, pressure gauge and safety valve of sand blasting machine should be checked regularly. The gas tank is dusted biweekly and the filter in the sand tank is checked monthly.
2, check the sand blasting machine ventilation pipe and sand blasting machine door is sealed. Five minutes before work, it is necessary to start the ventilation and dust removal equipment. When the ventilation and dust removal equipment fails, the sand blasting machine is prohibited to work.
3. Protective equipment must be worn before work, and no bare arm is allowed to operate the sandblasting machine.

4. The compressed air valve of sand blasting machine should be opened slowly, and the pressure is not allowed to exceed 0.8mpa.
5, sandblasting grain size should be adapted to the requirements of the work, generally applicable between 10 and 20, sand should be kept dry.
6. When the sandblasting machine is working, it is forbidden to approach irrelevant personnel. When cleaning and adjusting the operation parts, the machine should be shut down.
7, do not use sand blasting machine compressed air blowing body dust.
8. After the work, the sand blasting machine ventilation and dust removal equipment should continue to operate for five minutes and then close, in order to discharge indoor dust and keep the site clean.