The tips about use of sand blasting machine-Honest Horse china garnet sand

The sandblasting machine can be applied to a variety of workpiece sandblasting work, so what details should we pay attention to in the use process?

The sand blasting amount of the sand blasting machine is less, or even no sand: the sand in the sand storage tank is exhausted, turn off the gas, and add the abrasive ，Be careful not to put in too much, affect the sandblasting work
The sandblasting gun of the sandblasting machine may be blocked: after stopping the air, go to the nozzle to see if there is any impurity， If there is any matter, it must be cleaned up; There is also to see whether the abrasive sand is dry. too wet sand will also cause blockage
The sandblasting pipe is blocked: the pipe is blocked by dirt. turn the gas off，Remove the nozzle first， and then open the sandblasting machine , The foreign matter is blown out by the high pressure gas of the air compressor，If that doesn't work, should be removed for cleaning or replacement the pipe
The large amount of water by the compressed air of the air compressor supporting the sand blasting machine will not only cause sand wet, but also cause sand blast pipe wall wet and adhere to sand ，at the same time if the sand too wet will not be used normally, need clean out the sandblasting gun and the nozzle ,Pour out the abrasives Continue to use after drying in the sun
One time to add too much sand, sand overload will also cause blockage and not pressure suction sand; So when adding sand, we must pay attention to the appropriate amount, and slowly add.